– 11 –
Fresh Food Door and Hinges
WARNING: Use the appropriate safety equipment
and lifting techniques.
Caution: Use wood or a heavy plastic sheet to
protect the floor where the door will be placed.
Note: Unit must be removed from its installation
to remove center hinge.
Door
The door is of one-piece construction with foam
insulation. One-piece construction provides
superior thermal performance and reduces air
infiltration.
The inner door panel and outer door panel cannot
be separated and must be replaced as an
assembly.
1. Remove all food and bins from the inner door
liner.
2. Tape door to cabinet.
3. Remove the door closure mechanism (see
previous procedure).
4. Remove the upper hinge.
5. Remove tape and lift the door off center hinge.
6. Remove 4 T-27 Torx screws and center hinge.
Freezer Drawer
1. Loosen 4 screws connecting each side of the
freezer door to the slide/support assemblies.
2. Lift door up and out to remove.
Door and Drawer Gaskets
The fresh food door and freezer drawer have
magnetic gaskets that create a positive seal to the
front of the steel cabinet. The magnetic door
gaskets are secured to the fresh food door and
freezer drawer by a barbed edge that locks into a
retainer channel.
1. Starting at any corner, pull the old gasket out of
the retainer channel.
2. Soak the new gasket in warm water to make it
pliable.
3. Push the barbed edge of the gasket into the
retainer channel.
Center Hinge
Screws
Screws
Slide/Support
Assembly
Door
Left Side of Freezer Door
To Next Page
Loading...
