– 36 –
Diagnostic Mode
Enter the diagnostic mode by pressing both the freezer temperature pads (plus and minus) and the
refrigerator temperature pads (plus and minus) simultaneously. All 4 pads must be held for
approximately 3 seconds. Blinking “0’s” in both displays indicate the refrigerator has entered the test
mode.
Enter the appropriate display numbers as shown
below and press any pad other than the temperature
pads to activate that test mode.
rezeerF
yalpsiD
hserF
dooF
yalpsiD
scitsongaiDstluseRstnemmoC
02
kcehcnoitacinummoC
erutarepmeTneewteb
.lortnoCniaMdnalortnoC
.KOfiyalpsidrezeerfno"P"
.dnuofsimelborpsnaem"F"
07
rosneSdnalortnoC
.tseTmetsyS
dnarotsimrehthcaeskcehC
rof"0"dnassaprof"P"syalpid
.liaf
.woleb1etoneeS
10 .tseTrepmaD
,ylfeirbsesuap,repmadsnepO
.repmadsesolcnehtdna
12 .emiTnuR%001
ehtfo%001nometsysdelaeS
retfatuosemiT.emit
.ruoh1
13 .tseTllihc-erP
tinU.edomllihc-erpstratS
.nwostinolamronotsnruter
14 .tseTtsorfeD
.elcyctsorfedehtnoselggoT
.woleb2etoneeS
niagasserptsuM
.ffosretaehnrutot
.woleb2etoneeS
15 .teseRlortnoCniaM.tesermetsysasesuaC
16 .edoMcitsongaiDtixE
lortnocerutarepmetasesuaC
.teserdraob
Note 1: Display order is: 1) Fresh Food 1, 2) Fresh Food 2, 3) Custom Cool, 4) Thermistor test
results are P = pass, 0 = fail, S = short to 5 VDC, B = bad amplifier (replace main control).
Note 2: You must enter the defrost test again to toggle the defrost heater off at the end of the test.
The heater will not come on if the evaporator thermistor is warm.
To Next Page
Loading...
