ZKHSS2 Tubular Stainless Steel Handles
[STEP3 INSTALLASSEMBLEDHANDLES
. Slide the assembled panels into the door trim.
, Secure both trims using all the original screws.
Dispenser Models Only:
, The dispenser controls protrude beyond the face of
the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed.
, Remove the screws holding the top trim in place.
Lift off the trim.
, Place the freezer panel into the bottom channel
and slide into the hinge side trim.
, Reinstall the top trim piece with screws.
Reinsta// all origina/ screw.s
[STEP 41 INSTALL DISPENSER TRIM
For Dispenser Models Only:
There are two dispenser trims shipped with your
dispenser refrigerator. Note that the inside depth
of the frames are different. Choose the trim marked
3/4" overlay panels.
. Press and snap the dispenser trim into the dispenser
recess on the door,
IUispense_
rh Trim
22
To Next Page
Loading...
