B310-001&BDC © 02-2006
Operating instructions ACO 201
Interval Maintenance work
Every year • Have an authorised specialist workshop check the press capacity and
the state of wear
EN
Maintenance
Clean and lubricate the pressing device
WARNING
Risk of injury by switching on inadvertently
` Remove the accumulator before starting any
maintenance work on the tool
CAUTION
Damage to the device by moisture
` Never immerse the pressing device in water or other
liquids
Depress the release button on the accumulator and pull
1
out the accumulator
Clean the roller drive and locking pin of the pressing device
2
Use compressed air or a brush to remove dirt
3
Use WD-40® or equivalent to lubricate the roller drive, its
4
guide and the locking pin
21
To Next Page
Loading...
