Why is the flush volume inadequate in my Geberit Preda 116.072.00.1?
If the flush volume of your Geberit Toilets is inadequate, it could be due to a blocked basket filter in the solenoid valve. In this case, you should clean the basket filter. Alternatively, the water pressure reducing valve might be blocked, requiring you to replace it.
What to do if water is running continuously in Geberit Preda 116.072.00.1 Toilets?
If water is continuously running into the urinal ceramic of your Geberit Toilets, it could be due to a software fault. You can try to restart the urinal flush control. Alternatively, there may be a technical fault, in which case you should replace the control electronics or the solenoid valve.
Why is flushing inadequate in my Geberit Preda 116.072.00.1?
If the flushing out of your Geberit Toilets urinal ceramic is inadequate, it might be due to the flush time being set incorrectly. In this case, you should set the flush time.
Why are my Geberit Preda 116.072.00.1 flushing incorrectly?
If you are experiencing incorrect flushes (too soon, too late, or unwanted) with your Geberit Toilets, it could be due to a few reasons. First, the detection distance might not be set correctly; in this case you should optimise the detection distance. Another cause might be that the IR window is dirty or wet, so try cleaning or drying the IR window. Finally, if the IR window is scratched, you may need to replace the control electronics.
How to fix Geberit Preda 116.072.00.1 battery warning level 1?
If you're getting a battery warning level 1 (4 short signal tones) on your Geberit Toilets when entering the detection range, it means the batteries are dead or the rechargeable battery is empty. Replace the batteries or charge the rechargeable battery of the self-sustaining power supply.
General| Toilet Material | Ceramic |
|---|---|
| Color | White |
| Material | Ceramic |
| Mounting Type | Wall-hung |
| Type | Wall-hung toilet |
| Flushing system | Washdown |
| Installation | Wall-mounted |
To Next Page