Geberit Sigma40 - Operation; Starting the Odour Extraction Unit; Changing the Active Carbon Filter; Inserting an In-Cistern Block

EN
Operation
Starting the odour extraction
unit
4
Press the <Odour extraction> button.
ü The odour extraction unit starts
and the LED lights up.
The odour extraction unit
automatically stops after 10minutes.
To stop it earlier than this, press the
<Odour extraction> button again.
Inserting an in-cistern block
1 Open the actuator plate.
2 Insert an in-cistern block.
1
2
Changing the active carbon
filter
Prerequisite
–
When the LED on the <Odour extraction>
button flashes or you feel that odour
neutralisation has reduced, replace the
filter.
CAUTION
Possible health hazard
Impurities in the filter could lead to
contamination of the breathing air.
4 Replace the filter annually.
1 Open the actuator plate.
2 Remove the spent active carbon
filter, dispose of it and insert a new
active carbon filter.
3 Close the actuator plate.
4 Press the <Odour extraction> button
for 10s.
T
18014400372854027-1 © 09-2017
965.678.00.0 (03)
9