With light pressure, apply the steam diffuser directly in contact with the
fabric. With the free hand lightly stretch the fabric, and slide the
diffuser over the entire surface to be worked.
You can work the fabric from the outside, and also from the inside, by sliding
the diffuser in the garment and turn it towards the fabric.
Applying these two methods allows you to work quickly and to discover the
operating mode that suits you best.
If you use tap water, you should plan descaling operations.
The frequency depends on the level of lime in the water and the intensity
of the use of your device. When the lime scale is visible, it's time to clean
up. With heating, the lime deposit becomes as hard as stone and can
cause a total loss of performance.
To remove limescale:
- Fill the tank with water and a specific acid for steam appliances only. You
can also use household vinegar at 14 ° with a 50/50 water mixture.
- Place the tank on the base
- Heat for 30 seconds and stop heating.
- Leave on for 30 minutes and rinse with clean water.
- To rinse, remove the accessories, and empty the water by turning the
device upside down. Repeat the operation 2 times.
Cleaning :
Use a soft, damp cloth without detergent to clean the diffuser head, the
metal sole and the housing of the device.
Storage:
If your appliance is not to be used for a long time, empty the boiler and the
tank.
HOT WATER! before handling the device, leave to cool for 30
minutes after the last use
To Next Page
Loading...