3
8
in.k300 TechBook
Program menu
The program menu is accessible by holding down
the Light key for 5 seconds. In the program menu
the following parameters can be set: clock, filter
or purge cycles, economy mode and temperature units.
While in the program menu, use the Up or Down key to
adjust the parameters and use the Light key to jump to
the next parameter. The changes will be saved after the
confirmation of the last parameter only. If there is no action
taken for 10 seconds, the system will exit the program menu
without saving any changes.
Setting the clock
Enter the program menu by holding down the Light key
for 5 seconds. The display will show the current clock
setting with the hour flashing.
Depending on factory settings your system may be set
to 24-hour time or 12-hour time.
Setting the hour: Use the arrow keys to adjust the hour.
Press the Light key to jump to the next parameter,
the minutes.
Setting the minutes: Use the arrow keys to adjust
the minutes. Press the Light key to jump to the next
parameter, the filter or purge start time (FS).
Programming steps
Programming the filter/ purge cycles
Depending on system configuration your spa will
perform either a filter or a purge cycle. The filter cycle
menu consists of the following parameters: the start time
(FS), the duration (Fd) and the frequency (FF). The purge
cycle menu consists of the following parameters: the start
time (FS) and the frequency (FF).
A filter cycle consists of starting all the pumps and
blower in high speed for 1 minute (purge step) then,
the pump associated with the filter will run in low speed
for the remaining duration of the filter cycle (clean step).
A purge cycle is used when the spa is equipped with a
24 hour circulation pump which provides a continuous
clean step. It consists of starting all the pumps and
blower in high speed for 1 minute.
To Next Page
Loading...
Need help?
General
