Gecko in.k300 User Manual

3
in.k300 TechBook
7
Start or stop accessories
To start or stop an accessory, press the associated button.
Indicators will light up when the associated accessory is on.
When an accessory has more than two states, press the
button until it reaches the desired state. Indicators will
flash when dual speed pumps are on at low speed, and
will be solid at high speed.
If you have a blower it will be controlled by the Pump 2
key. The order of actions is as follows: pump 2 on;
pump 2 high speed (if applicable); blower on;
pump 2 off; blower off.
Keypad functions
Water temperature
The temperature shown on screen is the current water
temperature. Use the Up and Down buttons to set
the desired temperature.
The set point icon will appear at the top of
the screen. After 3 seconds without any change to
the set temperature value, the keypad will resume
the normal display.
Off Mode
Pressing Pump 1 for 5 seconds will enable the Off mode.
This mode allows you to stop all outputs including
automatic functions such as filter cycle, heat request
and smart winter mode for 30 minutes to perform quick
spa maintenance. When Off mode is active, the display
will toggle between the “OFF” message, the clock and
the water temperature. The spa light will flash for a few
seconds before the end of the 30 minutes to warn you
that the system is about to resume its normal operation.
Press Pump 1 or Pump 2 (if available) to restart the system
before the expiration of the 30 minute delay. When the
system resumes its normal operation, the display shows
“On“ for 3 seconds.

Gecko in.k300 Specifications

General

Brand	Gecko
Model	in.k300
Category	Keypad
Language	English

Summary

Keypad functions

Start or stop accessories

Control spa accessories like pumps and blowers by pressing dedicated buttons. Indicators show status.

Water temperature display

Displays current water temp. Use Up/Down buttons to set desired temperature. Set point icon appears.

Off Mode operation

Stops all outputs for 30 mins for maintenance. Toggles display between OFF, clock, and temp.

Programming steps

Program menu access

Access via holding Light key for 5s. Set clock, cycles, economy, and temp units.

Setting the clock

Adjust hour and minute settings for the spa's clock display. Supports 12/24 hour formats.

Filter and purge cycles

Configure filter or purge cycles, including start time, duration, and frequency.

Smart Winter Mode operation

Protects system from freezing by running pumps periodically. 'SWM' indicator shows status.

Error messages

HL Error

Warning! HL Error. Indicates a potential issue with the system's operation.

FLO Error

No flow condition detected for more than 2 hours. Check for blockages or pump issues.

OH Error

Warning! Spa temperature is too high. Indicates an overheating condition.

Prr Error

AOH Error

FLC Error

SP in Error

FrEr Error

RH NC Error

RH ID Error

SC ER Error

Fuse Errors (F1, F2, F3)

Hr Error

Software Validation Errors (UPL, BL)