HOW TO USE
MAKING HOT WATER
Turn the machine on and wait until the Espresso indicator light turns on.
Place a cup under the Steam Wand.
Slowly turn the Steam Control Knob counter clockwise to
" ON ", then press the
Espresso Button to allow for hot water to be dispensed.
Once the desired amount of hot water has been dispensed, press the Espresso
button again and turn the steam knob clockwise to
" OFF " .
1.
2.
3.
4.
Warning : The Steam Wand may be very hot during and after
use. to avoid burns, move it only by placing your fingers on the
rubber tip fitted on the Steam Wand.
Note : When hot water is dispensed from the Steam Wand, there
might be some water left inside. To drain it, we recommend dispens-
ing some steam for a few seconds.
Please press the Power button to turn off the machine after using.
12
Note : Please press the " On/Off " Button to turn off the machine
after using.
Note : When milk foaming is complete and you want to make
another cup of espresso, please don’t remove the metal funnel
immediately, it may cause coffee grounds to splashing. So make
sure the coffee machine is completely cooled before using. In order
to cool down the coffee machine properly, we suggest to proceed
“The Making hot water Function”.
To Next Page
