13
Base: Switch power off at Base.
Press and hold down ‘CH’ button, switch
power back on, continue to hold ‘CH’
button until both lights on the front start
flashing.
Base is ready for pairing.
Headset: Press and hold down the ‘-’
(minus) button.
While holding the button, open arms
and the green indicator lights up.
When light starts flashing pairing is
complete.
Cleaning & Maintenance
Note: DO NOT use alcohol, chemical
or spirit based cleaning agents.
Wipe Base and Headset clean with a
damp cloth.
Regularly remove and clean ‘Ear
pads’ with warm soapy water.
Two types of ear pad are supplied,
select the most suited to yourself.
18
19
20
To Next Page
Loading...