14
Install nano SIM Card and Battery
Always switch the telephone off and disconnect the charger
before removing the battery.
Take care when handling the SIM card. The SIM card and its
contacts can be easily damaged by scratches or bending.
To remove the battery compartment cover. Place your screen
down, then in the bottom left corner you have a small opening
and this is where you need to insert your fingernail to lift the
battery cover and unclip it.
Remove the battery (if battery already inside).
Slide a SIM with the gold contacts
face down under the silver SIM
holder as shown below.
You can insert 2 nano SIM cards into this telephone. There are
many reasons to do this, however, one important reason is that
if you use two SIMS from different providers you will probably get
better network coverage. However, just using one will be fine too!
Observe the battery contacts (the gold coloured contacts must
face towards the bottom right) and insert the battery.
Place the battery cover into position and clip the cover.
You can insert one micro SD
card to save the pictures.
Maximum 32G.
SIM card
SETTING UP
To Next Page
Loading...
