123
UserManual
VISO10–DCF
(MainlandEurope–NotUK)
1.Features
‐EasytoReadandUnderstandTimedisplay
‐PerpetualCalendarUptoYear2099
‐Dayofweek&Monthin8languagesuser
selectable
2.UnitAppearance
PartA‐LCD PartB‐Button
A1:DayoftheWeek
A2:RadioControlIcon
A3:Time
A4:Month
A5:Date
A6:Year
B1:“MODE/
”Button
B2:“▼”Button
B3:“RESET”Button
B4:“▲”Button
B5:“WAVE/
”Button
PartC‐Structure
C1:HangingHole
C2:BatteryDoor
C3:Stand
3.Gettingstarted:
z OpenthebatteryCover(C2).
z Insert 2 x AA size alkaline batteries observing
polarity[“+”and“–“marks].Thereis“click”sound
wheninsertbatteriestoreminduserthebatteries
wasinsertedcorrectly.
z Replacethebatterycompartmentcover.
4.TimeSetting
4.1ManualTimeSetting:
z In time display, hold “MODE/ ” button (B1)
for 3 seconds to enter Clock/Calendar setting
Mode.
z Press“▼” (B2) or “▲” (B4) button to adjust the
settingand press “MODE”button(B1)toconfirm
eachsetting.
z (By keeping the “▼” (B2) or “▲” (B4) button
pressed, that will accelerate the process and you
willreachthedesiredvaluefaster)
z The setting sequence is shown as follow:,
Weekday&MonthLanguage,12/24Hr,RCC(Radio
Clock) ON/OFF, Time Zone, Hour, Minute, Year,
Month,Day,DST.
z There are 8 languages, English, German, French,
Spanish, Italian, Dutch, Polish and Swedish, for
day‐of‐week&Month.
4.2RadioControlledTime:
z After the start‐up of the unit, the clock
automatically starts to scan the DCF time signal.
RadioControlIcon“
”(A2)flashesonLCD.
(A2)flashes
Indicating
nowisreceiving
DCFsignal
(A2)turnson
Indicatingsignalreceived
successfully
(A2)disappears
Indicatingsignalreception
failed
z TheclockautomaticallysynchronizeswiththeDCF
radio signal every day at 3.00 am to maintain
accuratetimekeeping.Ifsynchronizationwiththe
DCF radio signal fails, “
” on LCD disappears
and the clock then attempts to synchronize with
theDCFradiosignalat4.00amand5am.
z The clock can be set to scan the radio signal
manually by holding “
” button (B5) for 3
seconds. Each reception takes around several
minutes.If receptions fail,scanningstops. (“
”
on LCD disappear) and repeats again on nextfull
hour. E.g. scanning failed at 8:20a.m. It will scan
againat9:00a.m.
z Stop scanning DCF radio signal by holding “ ”
button(B5)for3seconds.
z “DST”shownon theLCDifit isinDaylightSaving
TimeMode.
Note:
(1) AllSettingmodewillautomaticallyexitinaround
15secondswithoutanyadjustment
(2) For Time Zone: If you receive no RC‐DCF
frequencysignal, the time zone should besetto
0. Time Zone is used in countries which can
received the DCF frequency signal but the time
zone
is different from German Time ( i.e.
GMT+1).
To Next Page
Need help?
General
