Need help?Do you have a question about the Gefen EXT-2DVI-DLKVM-CAT6 and is the answer not in the manual?
General| Category | Extender |
|---|---|
| Model | EXT-2DVI-DLKVM-CAT6 |
| Transmission Method | CAT6 |
| Supported Resolutions | Up to 1920x1200 |
| Audio Support | Yes |
| USB Support | Yes |
| Video Amplifier Bandwidth | 165 MHz |
| Input DDC Signal | 5 volts p-p (TTL) |
| Link Cable | CAT6 |
| USB Output Connector | USB Type A |
| Power Supply | 5V DC |
| KVM Support | Yes |
| Link Connector | RJ-45 |
| USB Input Connector | USB Type-A |
| Audio Input Connector | 3.5mm Stereo Jack |
| Audio Output Connector | 3.5mm Stereo Jack |
| Input Ports | DVI, USB, Audio |
| Output Ports | DVI, USB, Audio |
Emphasizes the need for high-quality CAT-6a cabling for optimal performance.
Crucial note: both CAT-6a cables must be the same length for Dual Link resolutions.
Lists supported resolutions, USB speeds, HDCP compliance, EDID management, etc.
Details the two DVI input ports (DVI In 1 and DVI In 2) for source connections.
Explains the four CAT-6 link ports (1.1, 1.2, 2.1, 2.2) for network connections.
Describes the USB In port for connecting the computer or USB host device.
Instructions for connecting DVI, USB, and CAT-6a cables between units and peripherals.
Configuration options for EDID management: Pass Through or Local EDID.
Controls DVI mode and HDCP pass-through based on connection type.
Explains how EQ 1 and EQ 2 trim pots compensate for cable distance and quality.
Step-by-step instructions for using a tool to adjust the trim pots.
Emphasizes using only CAT-6a and single, undivided cable segments.
To Next Page