Need help?Do you have a question about the Gefen EXT-HDMI-CAT5-444 and is the answer not in the manual?
General| Category | Matrix Switcher |
|---|---|
| Model | EXT-HDMI-CAT5-444 |
| HDMI Version | 1.3 |
| Power Supply | 5V DC |
| Maximum Pixel Clock | 225 MHz |
| EDID Management | Yes |
| RS-232 Control | Yes |
| IR Control | Yes |
| Input Ports | 4 HDMI |
| Output Ports | 4 |
| Supported Audio Formats | Dolby TrueHD, DTS-HD Master Audio, LPCM, Dolby Digital, DTS |
| Video Input Connector | HDMI |
| Video Output Connector | RJ-45 |
| Link Connector | RJ-45 |
| Input TMDS Signal | 1.2 Volts (peak-to-peak) |
| Input DDC Signal | 5 Volts p-p (TTL) |
| Power Consumption | 20W (max) |
| Operating Temperature | 0°C to +40°C |
Connect sources to Matrix inputs and local displays to Matrix outputs.
Link Matrix outputs to extension inputs using jumper cables.
Run and connect CAT-5e cables from Matrix to receivers.
Connect displays to receivers and power all units.
Example showing jumper connection between HDMI output and extension input ports.
Connect all jumpers for extension; omit for local displays.
Connect HDMI jumper, CAT-5e, display, and power supply to the receiver.
Explains the 8 DIP switches and default OFF position for configuration.
How to use Switch 1 for manual EQ and Boost settings for signal tuning.
Steps to adjust the trim pot for manual equalization.
How to use Switches 4 & 5 for different boost levels.
How to use Switch 8 to enable Pre-Emphasis for long cable runs.
Wiring diagram and color code for terminating CAT5 cables.
User control over EDID via DIP switch settings.
How to access and change EDID modes via DIP switches or RS-232.
Describes which DIP switches control EDID modes.
Details for EDID Modes 0 through A and their functions.
ASCII commands to change EDID management modes.
To Next Page
