General Precautions
Precautions on Safety
WARNING
Heed the following when removing or installing an attachment or option:
Consult with a Gehl dealer before installing optional attachments.
Do not use attachments that have not been approved by Gehl. Doing so may
compromise safety or adversely affect the machine’s operation or service life.
Gehl will not be held responsible for any injuries, accidents or damage to products
caused by the use of a non-approved attachment.
Choose a flat, hard surface to perform the operations. Also make sure there is enough
light and good ventilation.
Clean the area, remove any articles that may get in the way or be dangerous, and
remove any spilled oil or grease.
When removing or installing a backhoe attachment, place it in a stable position so
that it does not tip over.
Due to the risk of loads falling and/or hitting people, do not allow unauthorized
personnel in the work area.
Use a crane to carry heavy objects [25 kg (55 lb.) or greater].
When removing heavy parts, be sure to prop them up before removing them. When
lifting them with a crane, be careful to balance them properly.
Operating with loads suspended with the crane is dangerous. Place loads on a stand
and check for safety.
When attaching the attachments, failure to follow proper procedures could result in
serious damage. Consult a Gehl dealer beforehand.
Precautions on Installing Attachments
After replacing optional attachments or other special attachments, test-run them, then inspect
the hydraulic oil level and add oil if necessary.
In addition, consult a Gehl dealer for details of removal and installation procedures.
To Next Page
Loading...