Operating Precautions
Do not suddenly stop or lower the
working equipment
Sudden lowering or stopping of the working
equipment could cause the machine to tip
bowed forward.
Operate the working equipment carefully,
especially when the bucket is loaded.
Avoid overloading and off-center
loads
Filling the bucket in excess of the maximum
load and loading an off-center load will cause
the machine to become unstable and could
result in the machine tipping over. Loading
should be done evenly, should be less than
the: CTL55: 565 kg (1246 lbs.); CTL65: 835
kg (1841 lbs.); CTL75: 945 kg (2083 lbs.);
CTL85: 1190 kg (2624 lbs.).
Keep a safe distance from
electrical power lines
Never approach power lines with any part of
the machine and its load unless all local and
national required safety precautions have
been taken. Electrocution and death can
result from arcing, touching or even being
close to a machine that is in contact with or
near an electrical source.
Maintain the maximum possible distance
from power lines and never violate the
minimum clearance.
Always contact the nearest electric
utility and determine jointly what specific
precautions must be taken to ensure
safety.
Consider all lines to be power lines and
treat all power lines as energized, even if
it is known or believed that the power is
shut off and the line is visibly grounded.
Use a signal person to observe the
approach of any part of the machine or
load to the power line.
Caution all ground personnel to stand
clear of the machine and the load at all
times.
If the machine should come in contact
with a live electrical source, do not leave
the operator’s seat. Do not allow anyone
to approach or touch the machine.
Be especially careful of buried high-
voltage power lines.
To Next Page
Loading...
Need help?
General
