General Precautions
working in severe conditions where
large amounts of combustible debris
are present. Engine exhaust systems
provide numerous small pockets where
flammable debris can gather. Even small
accumulations close to hot exhaust
components can ignite and smolder.
4. Clean out all accumulated debris (twigs,
pine needles, branches, bark, leaves,
saw dust, small wood chips) and any
other combustible materials from inside
the machine belly pans or lower machine
structures as well as from areas in
proximity to the engine, fuel and hydraulic
oil systems no less frequently than at the
completion of each work shift.
5. Inspect the machine regularly for any
signs of diesel fuel or hydraulic system
leakage. Check for worn or damaged fuel
or hydraulic lines before starting up any
equipment.
6. Clean up any grease, diesel fuel, hydraulic
and lubricating oil accumulation and
spillage immediately.
7. Steam clean the engine, and belly pan areas
at least once a month or more frequently
when working in sever conditions where
large amounts of combustible debris are
present.
8. Use only nonflammable solutions for
cleaning the machine and components.
9. Inspect the exhaust system daily for any
signs of leakage. Check for worn, cracked,
broken or damaged pipes or muffler. Also
check for missing or damaged bolts or
clamps. Should any exhaust leaks or
defective parts be found, repairs must
be made immediately. Engine exhaust
leaks can cause fires. Do not operate
the machine until the exhaust leak is
repaired.
10. During daily operation of the machine,
the occurrence of exhaust leaks are
usually accompanied by a change or
increase in engine exhaust noise levels.
These audible warnings cannot be
ignored. Should any exhaust leaks occur
during operation, the machine must be
shut down immediately and not put back
to work until the necessary repairs have
been completed.
11. Before starting repair work, such as
welding, the surrounding area should be
cleaned and a fire extinguisher should be
close by.
12. Do not use the machine on top of or to
push piles of burning timber. A machine
fire will likely result.
What to do to prepare for a machine
fire
Prevent the fire from happening in the
first place by ensuring that all machine
systems are frequently inspected and
always well maintained.
Ensure that any hand held fire extinguishers
are charged and in working order. Fire
extinguishers require routine care. Follow
the manufacturer’s instructions for
inspection and maintenance shown on
the label of the fire extinguisher and in the
extinguisher manufacturer’s manual.
Ensure that you follow all national, state
/ provincial and local regulations dealing
with fire fighting in effect in your specific
geographic region.
Ensure that all information necessary for
you to immediately contact all sources
of help (local fire department, etc) in the
event of a fire emergency is recorded and
readily available at all times.
To Next Page
Loading...
Need help?
General
