Gehl Dyna-Handler 562 User Manual

This Maintenance Chart was developed to match the Service chapter of this manual. Detailed information on each
Service Procedure may be found in the Service chapter. A Maintenance Log follows the Interval Chart for record-
ing the maintenance procedures performed. Recording the 10 Hour (or Daily) service intervals would be imprac-
tical and is therefore not recommended.
IMPORTANT: Under extreme operating conditions more frequent service than the recommended
intervals may be required. You must decide if your operation requires more frequent service.
Chapter 10
MAINTENANCE
SERVICE PROCEDURE Every 10 Every 50 Every 100 Every 250
Hours Hours Hours Hours
(or Daily) (or Weekly)
Check Fuel Tank Level z
Check Fuel Filter (Drain Water If Required) z
Check Engine Oil z
Check Hydraulic Oil Level z
Check Tire Pressures z
Check Instruments Operation z
Check General Machine Operation & Condition z
Lubricate Weekly Grease Points z
Check Axle Oil Levels z
Check Air Filter Element z
Change Fuel Filter z
Check Wheel Nut Torque z
1,2
Check Transmission Oil Level z
Check Battery z
Change Engine Oil & Filter z
2
z
Change Hydraulic Oil & Filter z
2
1 - Only Until 450 Ft-Lbs (610 Nm) Is Maintained.
2 - Only New Machines.
MAINTENANCE INTERVAL CHART
907880/AP1298 58 PRINTED IN U.S.A.
Courtesy of CraneMarket.com

Gehl Dyna-Handler 562 Specifications

General

Brand	Gehl
Model	Dyna-Handler 562
Category	Multi Terrain Loaders
Language	English