PRINTED IN U.S.A. 55 908424/AP500
GENERAL INFORMATION
Decal Locations information is provided to assist in the
proper selection and application of new decals, in the
event the original decal(s) become(s) damaged or the
machine is repainted.
For correct replacement of decal(s) compare the loca-
tion illustrations to your machine before starting to
refinish the unit. Check-off each required decal using
the illustration reference number to find the part num-
ber, description and quantity in the list. Refer to the
appropriate illustration(s) for replacement location(s).
NEW DECAL APPLICATION
Before applying the new decals, surfaces must be free
from dirt, dust, grease and other foreign material. To
apply a solid-formed decal, remove the smaller portion
of the decal backing paper and apply this part of the
exposed adhesive backing to the clean surface while
maintaining proper position and alignment. Slowly
peel off the other portion of the backing paper while
applying hand pressure to smooth-out decal surface. To
apply a die-cut decal, first remove the backing paper.
Then, properly orient and position the decal onto the
clean mounting surface. After the decal is firmly
applied and smoothly pressed down, remove the front
covering paper.
PAINT FINISH
Use this list to order paint for refinishing:
906213 One Gal. Yellow
906317 One Gal. Charcoal Grey
906214 6 (12 oz. Spray Cans) Yellow
906318 6 (12 oz. Spray Cans) Charcoal Grey
Decal Kits
L98863 Model 552
L98864 Model 553
NOTE: Decals may be purchased in kits or indi-
vidually.
Chapter 9
DECAL LOCATIONS
CAUTION
ALWAYS follow the safety precautions on
decals. Replace decals if they are damaged, or
if the unit is repainted. If repainting, be sure
that all applicable decals are affixed in their
proper locations.
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
