EasyManuals Logo

Gehl Dynalift 552 User Manual

Gehl Dynalift 552
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
This Maintenance Chart was developed to match the Service chapter of this manual. Detailed information on each
Service Procedure may be found in the Service chapter. A Maintenance Log follows the Interval Chart for record-
ing the maintenance procedures performed. Recording the 10 Hour (or Daily) service intervals would be imprac-
tical and is therefore not recommended.
IMPORTANT: Under extreme operating conditions more frequent service than the recommended
intervals may be required. You must decide if your operation requires more frequent service.
Chapter 10
MAINTENANCE
SERVICE PROCEDURE Every 10 Every 50 First 100 Every 250
Hours Hours Hours Hours
(or Daily) (or Weekly)
Check Fuel Tank Level z
Check Fuel Filter (Drain Water If Required) z
Check Engine Oil z
Check Radiator Coolant Level z
Check Transmission Oil Level z
Check Hydraulic Oil Level z
Check Brake Reservoir Levels z
Check Park Brake Handle z
Check Tire Pressures z
Check Wheel Nut Torque z
1
Check Instruments Operation z
Check General Machine Operation & Condition z
Lubricate Weekly Grease Points z
Change Hydraulic Return Filter Element z
Change Transmission Filter z
Change Engine Oil & Filter zz
Check Axle Oil Levels z
Change Fuel Filter z
Check Transmission Oil Level z
Check Battery z
Check Boom Leaf Chains & Torque z
1 - Only Until 300 Ft-Lbs (407 Nm) Is Maintained.
MAINTENANCE INTERVAL CHART
PRINTED IN U.S.A. 61 908424/AP500
Courtesy of Crane.Market

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gehl Dynalift 552 and is the answer not in the manual?

Gehl Dynalift 552 Specifications

General IconGeneral
BrandGehl
ModelDynalift 552
CategoryForklifts
LanguageEnglish

Related product manuals