GREASING
Refer to the illustration and listing on the next page for
fitting locations. Wipe dirt from the fittings before
greasing them to prevent contamination. Replace any
missing or damaged fittings. To minimize dirt build-
up, avoid excessive greasing.
BASIC MACHINE
GREASE FITTING LOCATIONS
Every 50 Hours (or weekly)
Refer to the illustration on the facing page for loca-
tions.
--- BOOM AREA ---
1. Boom to frame upright pivot pins (2)
2. Rod end slave cylinder pivot pins (2)
3. Rod end lift cylinder pins (2)
4. Extend cylinder pivot pins (2)
5. Chain sheaves pins, (2)
6. Dynattach to boom nose pivot pins (2)
7. Tilt cylinder pivot pins (2)
8. Rotate cylinder pivot pins (2)
9. Rotate carriage wear pads (3)
10. Rotate pivot bearing (1)
11. Boom slide pads - as required, front and rear
--- CHASSIS AREA ---
12. Brake foot pedal linkage (1)
13. Wheel spindle pins (4 per axle)
14. Tie rod ends (2 per axle)
15. Axle to frame pivot pins (1 per axle)
16. Drive shafts (3 per each)
17. Leveling cylinder pivot pins (2)
18. Base end lift cylinder pivot pins (2)
19. Base end slave cylinder pivot pins (2)
Replacement Filters Chart
John Deere Engine
Oil Filter Element Gehl P/N L99420
Fuel Filter Element Gehl P/N L98978
Perkins Engine
Oil Filter Element Gehl P/N L97489
Fuel Filter Gehl P/N L88976
Transmission
Oil Filter Element Gehl P/N L99184
IMPORTANT: Do NOT use a substitute replace-
ment because high pressure may rupture filter.
Hydraulic System Filters
In-Tank Filter Element Gehl P/N L97489
Reservoir Sump Strainer Gehl P/N L62831
Air Cleaner
Dry Element Gehl P/N L120037
907879/AP1198 36 PRINTED IN U.S.A.
Courtesy of CraneMarket.com
To Next Page
Loading...