Transporting the Loader
Park the truck or trailer on a level surface. Be
sure the vehicle and its ramps have the weight capacity to support
the loader. Be sure the vehicle surface and its ramps are clear of
debris and slippery material that may reduce traction. Move the
loader on and off the vehicle ramp slowly and carefully. Failure to
follow these instructions could result in an overturn accident.
Observe all local regulations governing
the loading and transporting of
equipment. Ensure that the hauling
vehicle meets all safety requirements
before loading the skid loader.
1. Place blocks at the front and rear of
the hauling vehicle’s tires.
2. If the loader has an attachment, lift it
slightly off the ground.
3. Back the loader slowly and carefully
up the ramp onto the vehicle.
4. Lower the loader attachment to the
vehicle deck, turn off the engine and
remove the key.
5. Fasten the loader to the hauling vehicle
at the points indicated by the tie-down
decals.
6. Measure the clearance height of the
loader and hauling vehicle. Post the
clearance height in the cab of the
vehicle.
43 908274/BP1202
Fig. 28: Front Tie Down
Fig. 29: Rear Tie Down
WARNING
To Next Page
Loading...
