SERVICE
Before servicing the machine, unless
expressly instructed to the contrary, exercise the
MANDATORY
SAFETY SHUTDOWN PROCEDURE
(page 6).
After service has been performed, be sure to restore all guards,
shields and covers to their original positions before resuming
loader operation.
This Service chapter details procedures for performing routine maintenance
checks, adjustments and replacements. Most procedures are referred to in the
Troubleshooting and Maintenance Schedule chapters of this manual. Refer to
the Maintenance Interval Chart (page 71) for service intervals. Refer to the
separate engine manual provided for engine-related adjustments, lubrication
and service procedures.
Note: All service procedures, except those described under the “Dealer
Services” topic are owner-operator responsibilities.
Important: Always dispose of waste lubricating oils and hydraulic fluids
according to local regulations or take to a recycling center for disposal. Do
not pour onto the ground or down the drain.
Dealer Services
The following areas of component service, replacement and adjustments
require special tools and knowledge for proper servicing and should be
performed only by your authorized Gehl skid steer loader dealer: Hydrostatic
Components, Hydraulic System Axial Pump, Valves, Cylinders, Electrical
Components (other than the battery, circuit breakers) .
Replacement Parts
Part Description Gehl Part No.
Air Cleaner Element, Primary 137498
Air Cleaner Element, Secondary 137501
Hydraulic Oil Filter Element 137359
Hydrostatic Oil Filter Element 074830
Engine Oil Filter Element 137500
In-line Fuel Filter 137794
Spin-on Fuel Filter Cartridge 137499
Fresh Air Intake Filter (heater option) 138551
Recirculation Air Filter (heater option) 138545
Note: Part numbers may change. Your Gehl dealer will always have the latest
part numbers.
45 908274/BP1202
WARNING
To Next Page
Loading...
