Gelmar Tandem Larder Unit

To Next Page

STEP 8

Install the runner protective cover.

STEP 7

Adjust the L-shaped bracket with the castors, make sure the castors are

put into the U-shaped slot completely and tighten the screws with a

screw reamer.

Installation Continued...

STEP 10

Screw the screws out of the connecting strip, as the sequence revealed

in the picture, connect the slip frame and the top of the panel hangstrip

with the connecting strip (Attention: The connecting strip has the

dierentiation from left and right), and tighten the screws.

STEP 9

Install panel hangsrip.

STEP 11

Screw the screws out of the connecting strip, as the sequence revealed

in the picture, connect the slip frame and the bottom of the panel

hangstrip with the connecting strip (Attention: The connecting strip has

the dierentiation from left and right), and tighten the screws.

DIY Installation Guide

Tandem Larder

Unit

Cabinet Z

450 / 500 315

Need help?

Do you have a question about the Gelmar Tandem Larder Unit and is the answer not in the manual?

Summary

Installation

STEP 1: Drilling Top Cabinet Panel Holes

Drill 4 small holes Ø2.5mm on the top cabinet panel as per the specified dimensions.

STEP 2: Drilling Bottom Cabinet Panel Holes

Drill 12 small holes Ø2.5mm on the bottom cabinet panel as per the specified dimensions.

STEP 3: Install L-shaped iron

Install the L-shaped iron component, ensuring screws are tightened through the holes.

STEP 4: Attach L-shaped bracket with castors

Attach L-shaped bracket with castors to frame tube, fix frame to L-shaped iron sheets.

STEP 5: Fix Runners to Bottom Frame

Fix the runners onto the bottom frame panel using 12pcs tapping screws ST3.5x16.

STEP 6: Fix U-iron onto Cabinet Top

Fix the U-iron onto the cabinet top using 4 tapping screws ST3.5x16.

STEP 7: Adjust L-shaped bracket with castors

Adjust the L-shaped bracket with castors, ensuring full insertion into the U-shaped slot and tightening screws.

STEP 8: Install Runner Protective Cover

Install the runner protective cover.

STEP 9: Install Panel Hangstrip

Install the panel hangstrip according to the diagram and measurements provided.

STEP 10: Connect Slip Frame and Top Hangstrip

Connect slip frame and top hangstrip using connecting strip, ensuring correct left/right differentiation.

STEP 11: Connect Slip Frame and Bottom Hangstrip

Connect slip frame and bottom hangstrip using connecting strip, noting left/right differentiation.