6 Order data
The order data provide an overview of standard configurations.
Please check the availability before ordering. Other configurations available on request.
Note: Pneumatic connecting components (union and compressed air tube) for the connection between the process valve and
positioner are included with each positioner with a pneumatic connection (7) code 2 and 3.
Note: A valve specific mounting kit is required for assembly. For designing the mounting kit, the valve type, nominal size, control
function and actuator size must be stated.
Order codes
1 Type Code
Electro-pneumatic positioner
µPos
1434
2 Fieldbus Code
Without (3-wire version) 000
3 Accessory Code
Accessory Z
4 Action Code
Single acting 1
5 Set value input Code
4–20 mA, set value specification A
0–20 mA, set value specification B
0–10 V, set value specification C
6 Accessory housing material Code
Stainless steel base, PP cover 07
3.2315,
AlMgSi1/AlSi1MgMn
14
7 Pneumatic connection Code
Air supply M5 connection thread,
outlet M5 connection thread
1
Air supply via push-in connector, angle, for 4 mm
tube,
outlet via push-in connector, angle, for 4 mm tube
2
Air supply via push-in connector, angle, for 6 mm
tube,
outlet via push-in connector, angle, for 6 mm tube
3
Air supply via push-in connector, angle, for 1/4"
mm tube,
outlet via push-in connector, angle, for 1/4" mm
tube
U
8 Option Code
Without 00
4–20 mA, actual value output A0
0–20 mA, actual value output B0
0–10 V, actual value output C0
9 Flow rate Code
15 l/min 01
10 Travel sensor version Code
Potentiometer, 10 mm length 010
Potentiometer, 30 mm length 030
Remote potentiometer,
M12 connector
S01
11 Type of design Code
Standard
Dead zone presetting2% 2442
Dead zone presetting5% 2443
Inversed direction,
for quarter turn valves control function NO (2)
6960
12 CONEXO Code
Without
Integrated RFID chip for electronic identification
and traceability
C
6 Order data
www.gemu-group.com10 / 32GEMÜ 1434 µPos
To Next Page
Loading...
Need help?
General
