ACCELERATOR PEDAL
The accelerator pedal is located on the floor to the right of the brake pedal. To
begin moving or to increase vehicle speed, gradually push the accelerator pedal
toward the floor. Holding the accelerator pedal down continuously will accelerate
the vehicle to the maximum speed.
The accelerator pedal will function only if the key is on.
To slow the vehicle, release the accelerator pedal and apply the brake. The
electric motor provides additional braking force when the brake pedal is applied.
PARK BRAKE LEVER
WARNING
A rolling vehicle can cause serious injury. Always set the park brake when
leaving the vehicle unattended.
Remove the key from the ignition to prevent unauthorized use.
Always apply the brakes before setting
or releasing the park brake. To release
the park brake, press and hold the park
brake release
q
and move the lever to
the disengaged position. To set the park
brake, pull the park brake lever
w
slightly upward and toward the center of
the vehicle. If the key is turned off
without setting the park brake, an alert
will sound. Set the park brake to end the
alert.
When the park brake is set and the brake indicator is illuminated, the vehicle will
not move.
NOTICE
Be sure the park brake is fully disengaged before driving. Failure to do so can
lead to overheating of the rear brakes.
NOTE
The park brake is adjustable and should be checked periodically as outlined in
the Periodic Maintenance Chart beginning on page 57. Your authorized dealer
can assist.
35
FEATURES AND CONTROLS
To Next Page
Loading...
