PROPER SEAT BELT USE
This vehicle is equipped with three-point lap and diagonal seat belts for all
occupants. Always make sure the seat belts are secured for operator and all
passengers before operating.
When the key is turned on, the seat belt indicator lamp will illuminate if the
driver’s seat belt is not fastened.
To wear the seat belt properly, follow this procedure:
1. Pull the seat belt latch
q
downward and across your chest toward the
buckle at the inner edge of the seat.
2. Slide the buckle
w
up the webbing as far as needed for the belt to reach
across your hips. The belt should fit snugly across your hips and diagonally
across your chest. Make sure the belt is not twisted.
3. Push the latch plate into the buckle until it clicks.
4. Release the strap, it will self-tighten.
5. To remove slack in the lap belt portion of the belt, pull upward on the
shoulder belt. To loosen the lap belt if it is too tight, tilt the buckle and pull
the lap belt slightly longer.
6. To release the seat belt, press the square red button in the buckle’s center.
If necessary, slide the buckle down the webbing to allow it to retract fully.
44
FEATURES AND CONTROLS
To Next Page
Loading...
