32
OPERATION
Failure to operate the vehicle properly can result in a collision, loss of control, accident or rollover,
which may result in serious injury or death. Read and understand all safety warnings outlined in the
safety section of this owner’s manual.
Pre-Ride Inspection
Failure to inspect and verify that the vehicle is in safe operating condition before operating
increases the risk of an accident. Always inspect the vehicle before each use to make sure it's
in safe operating condition.
Item Remarks Page
Turn signals Ensure operation of all signal lamps 22
Mirrors Adjust mirrors for proper side and rear view -
Horn Ensure operation 22
Seat belts Check length of belt for damage, check latches for proper
operation
31
Brake system/pedal travel Ensure proper operation 29
55
Brake fluid Ensure proper level 55
Front suspension Inspect, lubricate if necessary -
Rear suspension Inspect, lubricate if necessary -
Steering Ensure free operation 56
Tires Inspect condition and pressure 7
57
Wheels/fasteners Inspect, ensure fastener tightness 57
Frame nuts, bolts, fasteners Inspect, ensure tightness -
Accelerator Ensure proper operation 29
Indicator lights/switches Ensure operation 24
Headlamp Check operation, apply dielectric grease when lamp is
replaced
59
Brake light/tail lamp Check operation, apply dielectric grease when lamp is
replaced
60
Latches (hood/tailgate/seat) Ensure all latches are secure -
Batteries Ensure full charges, proper water levels, clean terminals 62-64
Battery cables Inspect for proper cable routing and secure connections 63
To Next Page