7
1. If the display shows “HHH” after the program has been started, the temperature
inside is still too high (accompanied by 5 beep sounds). Then the program has to
be stopped. Open the lid and let the machine cool down for 10 to 20 minutes.
2. If the display shows“
LLL”after pressing the START/STOP button ( except the
programs BAKE), it means the temperature inside is too low (accompanied by 5
beep sounds), stop sound by pressing the
START/STOP button, open the lid and
let the machine rest for 10 to 20 minutes to return to room temperature.
3. If the display shows “
EE0” after you have pressed START/STOP, the temperature
sensor is disconnected please check the sensor carefully by Authorized expert.
1. Please check if all parts and accessories are complete and free of damage .
2. Clean all the parts according to the latter section “
Cleaning and Maintenance”
3. set the bread maker in baking mode and bake empty for about 10 minutes. After
cooling it down clean once more.
4. Dry all parts thoroughly and assembly them, so the appliance is ready for using.
1. Place the pan in position and turn it clockwise until it clicks in correct position. Insert
the kneading blade onto the drive shaft. It is recommended to ll holes with heat-
resisting margarine prior to placing the kneaders, this avoids the dough to stick
below the kneaders and the kneaders could be removed from bread easily.
2. Place ingredients into the bread pan. Please keep to the order mentioned in the
recipe. Usually the water or liquid substance should be put rstly, then add sugar,
salt and our, always add yeast or baking powder as the last ingredient.
Note: the maximum quantities of the our and yeast which may be used refer to the recipe.
FOR THE FIRST USE
WARNING DISPLAY
HOW TO MAKE BREAD
Yeast or soda
Drying redients
Water or liquid
Note: The maximum quantity of our and yeast separately is 490g and 6g.
3. With nger make a small indentation on one side of the our. Add yeast to indenta-
tion, Make sure it does not come into contact with the liquid ingredients or salt.
4. Close the lid gently and plug the power cord into a wall outlet.
5. Press the Menu button until your desired program is selected.
6. Press the
COLOR button to select the desired crust color.
7. Press the
LOAF button to select the desired size (1.5lb or 2lb ).
8. Set the delay time by pressing or button. This step may be skipped if you want
the bread maker to start working immediately.
To Next Page
Loading...
Need help?
General