11
FIRE PROTECTION
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “FIRE ALARM” will be displayed and the keypad sounder will pulse.
If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire
Department from an outside phone.
FIRE
FIRE ALARM
FIRE
FIRE TROUBLE
Resetting a Fire-Zone Alarm
1 Press the C button to silence the keypad sounder.
2 If there is no evidence of a fire, enter your User Code and pressJ to turn off the alarm Check smoke detector(s). If a smoke
detector tripped, its red alarm indicator light will be on.
After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector; etc.), pressing C again
will reset the keypad within about 10 seconds.
To Next Page
Loading...
