EasyManua.ls Logo

Gemini XPM-600 - Specifications

Gemini XPM-600
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 7
Specifications
Output Power EIA: 1kHz @ 1% THD
XPM-600 XPM-900 XPM-1200
Single Channel 8 230 310 400
Both Channels Driven 8 200 280 360
Single Channel 4 300 480 630
Both Channels Driven 4 270 400 530
Mono Bridge 8 550 800 1060
Dynamic Headroom: XPM-600 XPM-900 XPM-1200
8 1.4 1.4 1.3
4 2.2 2.2 2.2
Frequency Response............................................................20 Hz - 60 kHz
Total Harmonic Distortion......less than 0.1%, typical 0.03% at 1 kHz
Intermodulation Distortion.......................less than 0.05% (SMPTE)
Signal to Noise Ratio..........................100 dB below rated power, 8
Damping Factor..............................greater than 200 @ 8
Slew Rate.................................................................................25 V/µS
Voltage Gain....................................................................33 dB
Input Sensitivity (for rated power at 8 Ohm):
XPM-600 XPM-900 XPM-1200
0.9 Vrms 1.1 Vrms 1.2 Vrms
Input Impedance Unbalanced....................................................10 kOhms
Input Impedance Balanced.......................................................20 kOhms
Power consumption: XPM-600 XPM-900 XPM-1200
700 VA 900 VA 1100 VA
Note: power consumption is given at rated power at 8 per channel, both
channels driven.
AC Power Requirement:
(power connection is factory configured)............................120V/ 60 Hz
230V/ 50 Hz
Indicators.......................................................................1 Power Indicator
1 Signal LED per channel
1 Clip LED per channel
1 Protect LED per channel
1 Mono LED
1 Bridge LED
Cooling....................................2 Speed Dual Fan; Front-to-Rear Forced Air
Protection...........Short Circuit, DC, Thermal Cut-off, Sub/ultrasonic
Frequency Filters, In-rush Current Limiter, Turn-on Delay
Connectors:
Balanced/Unbalanced Inputs....................................1/4" Jack
Balanced Inputs............................................XLR Female Jack
Speaker Outputs (120V unit)..........................................5-way binding posts
Speaker Outputs (230V unit)...........Speakons (ch.A, ch.B and bridge)
Dimensions...................................19" x 13.75" x 3.5" (483 x 350 x 89 mm)
Weight XPM-600 XPM-900 XPM-1200
25.8 lbs 29 lbs 31.2 lbs
11.7 kg 13.2 kg 14.2 kg
* Specifications and design are subject to change without notice for
purpose of improvement.

Related product manuals