Gemtech GT5020 - Basic Thermostat Setup and Use; Configure Mode and Fan Settings; Setting the Desired Temperature; Operating Your Thermostat

PG 2
1 Configure
Set HEAT/COOL mode switch to HEAT or COOL. The unit will display the ambient
temperature. Set the Fan switch to automatic.
Your thermostat is now in operation.
In the winter, set the system switch to HEAT to control your heating system.
In the summer, set the system switch to COOL to control your air conditioner.
In spring and fall or when windows are open, you can set the system switch OFF.
Setting the FAN switch to AUTO automatically runs your system's fan during heating and
cooling.
Setting the FAN switch to ON runs your system's fan continuously even without heating
or cooling.
2 Set Temp
3 Operate
Press the TEMP UP and TEMP DOWN buttons to select the desired temperature.
The TARGET icon will be displayed with your desired temperature. ( The display will
return to the current temperature in 5 sec if no button is pressed).