Generac Power Systems 1043-2 User Manual

Generac 2700PSI High Pressure Washer
GENERAC
The Reliable Ones
6
ASSEMBLY
Read entire owners manual before you attempt to
assemble or operate your new pressure washer.
Your new pressure washer has been assembled at
the factory with the exception of those parts left
unassembled for shipping purposes.
REMOVE PRESSURE
WASHER FROM CARTON
 Remove parts box included with pressure washer.
 Slice two corners at guide handle end of carton
from top to bottom so the panel can be folded down
flat, then remove all packing material.
 Roll pressure washer out of carton.
CARTON CONTENTS
Items in the carton include:
 Main Unit
 Manual Bag
 Owners Manual
 Engine Owners Manual
 Nozzle Cleaning Kit
 ORing Maintenance Kit
 Parts Box (which includes the following):
 Video
 Wireform
 Goggles
 Spray Gun
 Dual Lance
 High Pressure Hose
 Handle
 Handle Parts Bag (which includes the following):
 2 carriage bolts
 2 knobs
If any of the above parts are missing or damaged, call
the pressure washer helpline at 18002701408.
PREPARING THE
PRESSURE WASHER
FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,
call the Pressure Washer Helpline at 1-800-270-1408.
To prepare your pressure washer for operation you
will need to perform these tasks:
 Attach the handle and attach the wire form that
holds high pressure hose and spray gun.
 Connect high pressure hose to the spray gun and
the pump and connect water supply to the pump.
 Add oil to engine crankcase.
 Add fuel to fuel tank.
Attach the Handle
 Place the handle onto the bottom the handle
supports already connected to the main unit. Make
sure the holes in the handle align with the holes in
the handle supports (Figure 1).
Note: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
Figure 1 — Attach the top of the handle to the
bottom of the handle.
Make sure
the holes in
the handle
supports
are aligned
with the
holes in the
handle.
Handle
Handle
Supports

Generac Power Systems 1043-2 Specifications

General

Brand	Generac Power Systems
Model	1043-2
Category	Pressure Washer
Language	English