EasyManuals Logo

Generac Power Systems 1439-0 User Manual

Generac Power Systems 1439-0
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Generac Portable Products 2,100 PSI High Pressure Washer
6
Insert the carriage bolt through the left hole (from
the rear of the unit) and attach a plastic knob.
Tighten by hand (Figure 2).
Insert the carriage hook through the right hole (from
the rear of the unit). Pull the recoil handle out slowly.
Place the recoil string through the hook and attach
the plastic knob. Tighten by hand (Figure 2).
Insert the wire form with the longer arm positioned
on the left. From the rear of the unit, the hook
should resemble a J (Figure 3).
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
Place pressure washer on a level surface.
Refer to the engine owners manual to add
recommended oil to engine.
NOTE: Check oil often during engine breakin. Refer
to engine owners manual for recommendations.
Add Gasoline
DANGER! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot.
Do Not smoke when filling fuel tank.
WARNING! Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away
any fuel spillage from engine and equipment
before starting.
Use fresh, clean unleaded automotive gasoline and
store in approved, clean, covered containers. Use
clean fill funnels. Never use stale gasoline left over
from last season or gasoline stored for long periods.
Clean area around fuel fill cap, remove cap.
Slowly add UNLEADED regular gasoline to fuel
tank. Use a funnel to prevent spillage. Slowly fill tank
to about 1/2 below the bottom of the filler neck
(Figure 5).
Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must attach all hoses before you
start the engine. Starting engine without all hoses
connected and water supplied will damage the pump.
Uncoil the high pressure hose and attach one end of
the hose to the base of the spray gun (Figure 6).
Tighten by hand.
Figure 3  Attach Wire Form to Handle
Figure 2  Secure Handle
Figure 5 Add Gasoline to Fuel Tank

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems 1439-0 and is the answer not in the manual?

Generac Power Systems 1439-0 Specifications

General IconGeneral
BrandGenerac Power Systems
Model1439-0
CategoryPressure Washer
LanguageEnglish

Related product manuals