Generac 2500PSI High Pressure Washer
AASSSSEEMMBBLLYY
6
High Pressure Washer
Insert the carriage bolts through the aligned holes
on the handle and attach the plastic knobs. Tighten
the knobs by hand (Figure 2).
Insert the wire support with the longer arm positioned
on the left. From this view (from rear of unit) the hook
should resemble a J.
(Figure 3)
Add Engine Oil
IMPORTANT: Any attempt to crank or start the
engine before it has been properly serviced with the
recommended oil may result in an engine failure.
Note: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF,SG, SH or rated SAE 30 weight.
Select the oils viscosity grade according to your
expected operating temperature. Do Not Use SAE
10W40 Oil.
Although multi-viscosity oils (5W30, 10W30, etc.)
improve starting in cold weather, these multi-viscosity
oils will result in increased oil consumption when used
above 32°F. Check your engine oil level more
frequently to avoid possible damage from running
low on oil.
Place pressure washer on a level surface.
Clean area around oil fill and remove oil fill cap
(Figure 4)
Wipe dipstick clean. Pour oil into oil fill opening until
oil reaches FULL mark on the dipstick. Stop
occasionally to check oil level. DO NOT OVERFILL.
Install oil dipstick, hand tighten securely.
Note: Check Oil Often During Engine Breakin.
Add Gasoline
DANGER! Never fill fuel tank indoors.
Never fill fuel tank when engine is running
or hot. Do not smoke when filling fuel tank.
WARNING! Never fill fuel tank completely
full. Fill tank to about 1/2" below the bottom
of the filler neck to provide space for fuel
expansion. Wipe away any fuel spillage
from engine and equipment before starting.
WARNING! DO NOT operate or refuel
engine with spark plug access hole cover
removed. Allow engine to cool 2 minutes
before refueling.
Figure 3 — Fit wire form on handle.
Figure 4 — Add oil to engine crankcase. Do not
attempt to start engine without
adding oil.
Oil Fill Cap
Figure 2 — Insert the carriage bolts
and attach the knobs.
colder 32°F warmer
5W30 SAE 30
To Next Page
Loading...
Need help?
General
