Owner’s Manual for Flameless Air Heater 11
Operation
Adjusting Heater Output
The heater has two modes, AUTO and MANUAL. The
current mode displays at the top of the controller screen.
AUTO Mode
In AUTO mode, output temperature is manually set, as
follows:
• To increase output temperature, press (+) (Figure
3-6, item A)
• To decrease output temperature, press (-) (Figure
3-6, item B)
Figure 3-6. AUTO mode.
MANUAL Mode
In MANUAL mode, heater output can be set to minimum
fan or maximum fan, as follows:
• For minimum fan, press MIN FAN (Figure 3-7, item
A).
• For maximum fan, press MAX FAN (Figure 3-7,
item B).
Figure 3-7. MANUAL mode.
Heater and Engine Shutdown
1. Press OFF to stop the heater (Figure 3-7, item C).
The screen displays “Heater is cooling down--
Please wait” (Figure 3-8).
Figure 3-8. Heater Cooling
NOTE: During cool down, the ON button is disabled.
When cool down is complete, the screen displays as
shown in Figure 3-9.
Figure 3-9. Cool-down Complete
2. When the control screen indicates it is safe to turn
off the engine, turn the ignition key to OFF.
&$87,21
D
8QLWGDPDJH'RQRWVWRSHQJLQHEHIRUHKHDWLQJ
XQLWLVFRROHG'RLQJVRFRXOGUHVXOWLQXQLWGDPDJH
To Next Page
Loading...
Need help?
General