EasyManuals Logo

Generac Power Systems PowerBOSS Contractor 1648-0 User Manual

Generac Power Systems PowerBOSS Contractor 1648-0
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
, WARNING
WHEN ADDING FUEL
Turn generator OFF and let it cool at least 2 minutes before
removing gascap.Loosen cap slowly to relieve pressure in tank.
Fill fuel tank outdoors.
DO NOT overfill tank.Allow spacefor fuel expansion.
Keep fuel away from sparks,open flames, pilot lights, heat,and
other ignition sources.
DO NOT light a cigarette or smoke.
NHEN OPERATING EQUIPMENT
DO NOT tip engine or equipment at anglewhich causesfuel
to spill.
'HEN TRANSPORTING OR REPAIRING EQUIPMENT
Transport/repair with fuel tank EMPTY or with fuel shutoff
valve OFF.
Disconnect spark plug wire.
NHEN STORING FUEL OR EQUIPMENT WITH FUEL
IN TANK
Store away from furnaces,stoves, water heaters,clothes
dryers or other appliances that havepilot light or other
ignitionsource becausethey can ignitefuel vapors.
DANGER
DO NOT allow any open flame, spark, heat,or lit cigarette
during and for several minutes after charging a battery.
Wear protective goggles,rubber apron, and rubber gloves.
, WARNING
DO NOT touch hot surfaces.
Allow equipment to cool before touching.
CAUTION
DO NOT tamper with governedspeed.Generator supplies
correct rated frequency and voltage when running at governed
speed.
DO NOT modify generator in any way.
CAUTION
See"Don't Overload Your Generator" on page I h
Start generator and let engine stabilize before connecting
electrical loads.
Connect electrical loads in OFF position, then turn ON for
operation.
Turn electrical loads OFF and disconnect from generator
before stopping generator.
CAUTION
Use generator only for intended uses.
tf you have questions about intended use,ask dealer or
contact Generac.
Operate generator only on level surfaces.
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors.
DO NOT insert any obiects through cooling slots.
tf connected devices overheat, turn them off and disconnect
them from generaton
Shut off generator if.'
-electrical output is lost;
-equipment sparks,smokes,or emits flames;
-unit vibrates excessively.
/
3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems PowerBOSS Contractor 1648-0 and is the answer not in the manual?

Generac Power Systems PowerBOSS Contractor 1648-0 Specifications

General IconGeneral
BrandGenerac Power Systems
ModelPowerBOSS Contractor 1648-0
CategoryPortable Generator
LanguageEnglish

Related product manuals