POTENTIAL DAMAGE TO ANTENNA
The antenna limit switches and resolvers have been pre-set to allow for maximum antenna
performance. Any subsequent adjustment may jeopardize antenna performance and/or result in
damage to the antenna.
SAFETY NOTICE
The following safety procedures are listed to remind those performing any work on the antenna
system that safety rules must be observed. Failure to observe safety rules may result in serious
injury or death. Always work safely and in accordance with established procedures.
• It is recommended that a lockout/tagout process be utilized while servicing the antenna
system. In the United States, see OSHA 1910.147.
• Care shall be taken in all operations to safeguard other people as well as property and
to comply with all local safety procedures as established by the customer’s site
representative, as well as local building codes and fire protection standards.
• All persons performing work on the antenna system shall also comply with the
Occupational Safety and Health Act (OSHA) standards and all other federal state and
local laws, ordinances, regulations and codes relating to designated work.
• Unless the customer’s representative on site specifically designates an individual
responsible for site safety, the SATCOM Technologies Site Supervisor shall be
responsible for and establish a site safety program for the SATCOM Technologies
installation work. The site safety program shall incorporate all SATCOM Technologies
safety procedures and requirements
• Never make internal adjustments or perform maintenance or service when alone or
fatigued.
ELECTROMAGNETIC RADIATION
• It is recommended that a lockout/tagout process be utilized while servicing the antenna
system. In the United States, see OSHA 1910.147.
• Do not stand in the direct path of the feed system when the system is transmitting!
• Do not work on the feed system when the system is on!
ALWAYS WORK SAFELY!
600-1152A iv
To Next Page
Loading...