EasyManua.ls Logo

General Technomatic ONX-997 - Maintenance

Default Icon
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Matters Needing Attention
3. Do not place heavy, heating source or
wet articles on the top of the washing
machine.
4. Do not hot wash foam rubber or
sponge-like materials.
5. Before washing, do up zippers, buttons
and clothes straps and put small articles,
such as socks, laces or bras, into a
washing bag or a pillow.
Steel wires in bras will
pop out during washing;
never wash bras
containing steel wires.
6.Do not open the detergent distribution
drawer during the wash cycle.
7. The door is fitted with a self-lock device
and will not open until 2~3 minutes after
the washing machine stops. Do not force
the door open. Do not open the door if
water level can reach the porthole.
8. After each wash program, turn off the tap
to prevent leakage; and unplug the
washing machine and wipe clean the lower
part of the porthole.
9. Keep the door slightly open when the washing machine is not in use to prevent
formation of odors; do not cover the washing machine with plastic cover so that inside
dampness cannot be kept in.
14
Maintenance
5. To prevent blockage to the water supply by ingress of
foreign substances, clean the water inlet and inlet filter
regularly.
6. If the machine is to be moved to a distant place, replace the vibration absorbing
locks (packing screws, rubber gaskets) removed before installation to prevent damage
as shown below.
Remove the back cover and
take out the three rubber
plugs.
Insert the channel steel vibration
locks and the bolts.
Insert the rubber bolt
gaskets.
Replace the back cover.
7. If the washing machine is left idle for a long
period, pull out the electrical plug and turn off the
water tap. Open the door to prevent formation of
moisture and odors. Let the door open while not
used.

Related product manuals