Note: This information applies only to the General 330H, 343H and 357H Hole Diggers.
CAUTION!
300 Series Hole Diggers are shipped from the factory without oil in the
transmission. Oil is provided in the original shipping carton. Failure to
properly ll and operate the transmission with oil can result in damage that
is not covered by the product warranty program.
Need help?
Call us at 800.533.0524, or
email: support@generalequip.com
Steps below to check oil level.
1. Do not check oil level with the engine running!
2. Place the Hole Digger on a level surface.
3. Wipe any dust or dirt from the transmission oil ller/level
plug area.
The oil ller/level plug is located on the side of the
transmission. FIGURE 1.
4. Remove the plug with a suitable wrench.
FIGURE 2.
HOLE DIGGING: MAINTENANCE
FIGURE 1.
April 2013 • ISSUE 16P
Question: How do you check the transmission oil level in
300 Series Hole Diggers?
Answer: Follow procedure in the Operator Manual.
To Next Page
Need help?
General