9
SET UP
OPERATION
▪ Select a place as close as practical
to the work site. Ensure the location is
clear of traffic.
▪ Place the laser on a level surface such
as a bench or mount.
▪ To turn the instrument on, slide the
power switch to the “on” position. Self
levelling will commence and all the
beams will activate.
▪ If the instrument is outside the self
levelling range the instrument will not
level causing the laser beam to flash
on and off repeatedly. If this occurs,
reposition the instrument onto a level
surface until the instrument can level off.
▪ Press the line mode button on the
control panel to cycle through the active
beams.
To Next Page
Loading...
