Need help?Do you have a question about the General ToolSmart and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Continuity Test | Yes |
| Diode Test | Yes |
| Battery Type | 9V |
| Auto Power Off | Yes |
| Safety Rating | CAT III 600V |
Turn on the digital multimeter by rotating the yellow dial.
Activate Bluetooth on the multimeter; a solid "B" indicates readiness.
Access the Toolbox, select Digital Multimeter, and tap Connect.
Allow the phone and multimeter to establish a connection.
Press the save button on the app to store recorded measurement data.
Configure upper and lower limits for quick out-of-range detection.
App screen updates automatically to reflect multimeter dial changes.
Tap the calculator button from the main dashboard.
Drag and drop measurements or type values to calculate Voltage, Resistance, or Current.
Display the computed Ohm's Law values.
Press the calculator button to access the temperature averaging feature.
Select number of temperatures and drag/type values into the fields.
Display the calculated average temperature.
Tap the camera icon on the dashboard to open the camera interface.
Take a new photo or select an existing one from the phone's gallery.
Control flash, use front/rear camera during photo capture.
Decide to keep the captured image or take another one.
Navigate to the gallery from the dashboard via the gallery button.
Choose a photo from the gallery to add measurement data to.
Place and move text boxes on the photo to input or drag measurement values.
Drag logged measurements into the boxes on the photo for annotation.
Save the final picture with all logged measurements included in the gallery.
Open the app menu and tap the Settings button.
Change units for measurement (e.g., English/Metric) and temperature (Fahrenheit/Celsius).
Set option to save captured images to the phone's gallery.
Access terms & conditions and privacy policy information.
To Next Page
