7
USING YOUR LASER
Setting Up
Power Supply
Operation
‣ Select a place as close as practical to the work site.
Ensure the location is clear of traffic.
‣ Place the laser on a level surface such as a bench or mount.
The X5 is powered by three AA alkaline batteries.
‣ To turn the unit on slide the power switch to “on” position. Self
levelling will commence and all dot and line beams will appear.
‣ If the unit is outside the self levelling range the unit will not
level causing the speaker to beep and the laser beam to turn off.
‣ Press the dot / line mode button on the control panel to cycle
through the active beams.
To Next Page
Loading...
