To Next PageTo Next Page
Need help?Do you have a question about the GeneralAire AC-22 and is the answer not in the manual?
A 26-inch clearance is mandatory for media frame removal from the cabinet.
Before starting installation, ensure the furnace electricity is turned off.
Pull the front cover, slide out the media carrier, and remove the old furnace filter.
Place the air cleaner cabinet into the return air system, using duct supports if needed.
Slide the media frame into the cabinet with the airflow arrow pointing towards the blower.
Install the condition indicator and nameplate in an upright orientation.
Restore power, run the furnace, calibrate the indicator, and check equipment performance.
The condition indicator gauge signals when media replacement is required.
Turn off power, remove carrier, loosen and remove pleat spacers from the frame.
Place the new media pack onto the frame, aligning holes with the cardboard strips.
Insert pleat spacers between media pleats, pressing ends down to engage the frame.
Slide the assembled media frame into the cabinet with the airflow arrow pointing towards the blower.
Turn on power, run blower, and adjust the calibration screw for the indicator.
Diagram illustrating all available parts for the GeneralAire AC-22 air cleaner.
Table detailing pressure drop (in W.C.) for various air flow rates (CFM).
Details the lifetime limited warranty, exclusions, and consumer rights.
Addresses and websites for General Filters, Inc. and Canadian General Filters, Ltd.
Benefits, features, and maintenance aspects of the air cleaner.
Instructions and form fields for registering the product warranty.
A 26-inch clearance is mandatory for media frame removal from the cabinet.
Before starting installation, ensure the furnace electricity is turned off.
Pull the front cover, slide out the media carrier, and remove the old furnace filter.
Place the air cleaner cabinet into the return air system, using duct supports if needed.
Slide the media frame into the cabinet with the airflow arrow pointing towards the blower.
Install the condition indicator and nameplate in an upright orientation.
Restore power, run the furnace, calibrate the indicator, and check equipment performance.
The condition indicator gauge signals when media replacement is required.
Turn off power, remove carrier, loosen and remove pleat spacers from the frame.
Place the new media pack onto the frame, aligning holes with the cardboard strips.
Insert pleat spacers between media pleats, pressing ends down to engage the frame.
Slide the assembled media frame into the cabinet with the airflow arrow pointing towards the blower.
Turn on power, run blower, and adjust the calibration screw for the indicator.
Diagram illustrating all available parts for the GeneralAire AC-22 air cleaner.
Table detailing pressure drop (in W.C.) for various air flow rates (CFM).
Details the lifetime limited warranty, exclusions, and consumer rights.
Addresses and websites for General Filters, Inc. and Canadian General Filters, Ltd.
Benefits, features, and maintenance aspects of the air cleaner.
Instructions and form fields for registering the product warranty.
General| Brand | GeneralAire |
|---|---|
| Model | AC-22 |
| Category | Air Cleaner |
| Language | English |
