adjust the redundancy, scan the Trioptic Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the Programming Chart. Then scan the
Save bar code. Default = 0.
Interleaved 2 of 5
< Default All Interleaved 2 of 5 Settings >
Interleaved 2 of 5 On/Off
Check Digit
No Check Digit indicates that the scanner reads and transmits bar code data with
or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads Inter-
leaved 2 of 5 bar codes printed with a check digit, but will not transmit the check
digit with the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads Inter-
leaved 2 of 5 bar codes printed with a check digit, and will transmit this digit at the
end of the scanned data. Default = No Check Digit.
Trioptic Redundancy
* On
Off
* No Check Digit
Validate, but Don’t Transmit
To Next Page
Loading...