Straight 2 of 5 Industrial Redundancy
If you are encountering errors when reading Straight 2 of 5 Industrial bar codes,
you may want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the number of
errors. Note that the higher the redundancy count, the longer it will take to decode
the bar code. To adjust the redundancy, scan the Straight 2 of 5 Industrial Redun-
dancy bar code below, then scan a redundancy count between 0 and 10 on the
Programming Chart. Then scan the Save bar code. Default = 0.
Straight 2 of 5 IATA (two-bar start/stop)
<Default All Straight 2 of 5 IATA Settings>
Straight 2 of 5 IATA On/Off
Straight 2 of 5 IATA Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description for additional information. Minimum and Maximum lengths = 1-48.
Minimum Default = 4, Maximum Default = 48.
Straight 2 of 5 Industrial
Redundancy
On
* Off
Minimum Message Length
To Next Page
Loading...