GS1 DataBar Omnidi
rectional
< Default All GS1 DataBar Omnidirectional Settings >
GS1 DataBar Omnidirectional On/Off
GS1 DataBar Omnidirectiona
l Redundancy
If you are encountering errors when reading GS1 DataBar Omnidirectional bar
codes, you may want to adjust the redundancy count. Redundancy adjusts the
number of times a bar code is decoded before transmission, which may reduce the
number of errors. Note that the higher the redundancy count, the longer it will take
to decode the bar code. To adjust the redundancy, scan the GS1 DataBar Omnidi-
rectional Redundancy bar code below, then scan a redundancy count between 0
and 10 on the Programming Chart. Then scan the Save bar code. Default = 0.
GS1 DataBar Limited
< Default All GS1 DataBar Limited Settings >
* On
Off
GS1 DataBar
Omnidirectional Redundancy
To Next Page
