Date: 2021-08-17
Copyright of the European Union is effective (Copyright EU) (c) 2021 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
66
#INVOLT0/1/2 input voltage in V
#LASTERR last error occurred
#LOAD current load
#LOCATION location description of the device
#MANUFACTURER manufacturer of the UPS the device is installed to
#MODEL UPS model
#OUTFREQ0/1/2 output frequency in Hz
#OUTPHASES Number of output phases
#OUTPOWER0/1/2 Load in %
#OUTPUT_VOLT0/1/2 output volt in V
#OUTPUTCURRENT0/1/2 current output in A
#OVERLOAD Overload
#PHASES phases
#POWER UPS Power
#RECHARGETIME Time to fulfil recharge cycle
#RESTORETIME Time to restore UPS after usage
#RUNTIME Runtime since last start-up
#SECONBAT() Seconds on battery
#SELFTESTDATE Date of the last self-test
#SERVER IP address of the SNMP adapter
#STATUS System status
#SYSDATE() System date
#SYSTIME() System time
#TEMPDEG Temperature in °Celsius
#TIMEZONE Time zone
#VOLTAVAI UPS related - The UPS provides input voltage queries
Sensors and devices
SITEMONITOR 6 specific information
SITEMONITOR 6
The SITEMONITOR has 64 digital inputs and, via 2 special AUX ports, offers the possibility of connecting a relay board specially
developed for the SITEMONITOR for up to 8 outputs in addition to analogue sensors. In total, the SITEMONITOR provides 12
volts of operating voltage for external sensors if required and 1 ampere of current distributed over the entire number of
connected devices. Both active and passive devices can be connected.
The cable tree
With 64 digital inputs, installations with up to 100 cables are a realistic scenario. For this reason, the SITEMONITOR 6 offers the
option of an optional cable comb:
There are 4 screws on the back of the unit - these hold the cable comb in the delivery position:
Remove the screws and bring the strain relief into position. Then fasten the strain relief again with the screws. To avoid damage
to the unit, please use only the screws provided for this purpose.
To Next Page
Loading...
Need help?
General
