1. Choose the entry
- System
- Network
at the drop-down menu on the left side.
2. Enter the values for
- Local Address
- Subnet Mask
- Default Gateway
("DNS-Server", if desired)
3. Press the button “Apply” to commit the changes.
4. Choose the entry
- System
- Date & Time
in the drop-down menu.
5. Enter the „IP Address“ of your timeserver and
synchronize the CS141 with this server.
The timeserver settings are important for the event- /
alarm logging. (If no timeserver is configured the time
will be set to 01.01.2000 00:00).
6. The changes of each configuration page have to
commit by pressing the button “Apply”.
7. Choose the point
- Devices
- UPS
- Setup
in the drop-down menu for the UPS configuration.
8. Choose the „UPS Model“, which is connected to
the CS141.
9. Click on the button “Apply” to save the changes.
More Information about the UPS settings are
available in the CS141 User Manual.
7. Configure the IP address of the CS141
Basic Network Settings
English
To Next Page
Loading...
